FSUIPC Offset richtig in FSBUS einbinden?

[bwr014]

Hello Peter,

I have been testing things here as well. Good to hear you got it working.

I just used the standard MIX eng 1(fsbus router) to get the fuel switch go on and off... ( i noticed that it is not 1 but just I16,0, RW..)

Not sure why you have put a 1 there...

Only problem is that i cant get my eng. in fs to start because the oilpresure isnt going up so i assum behind that offset 0890 there is something else that also is needed to get the eng started it now stick to a 25% and doesnt go higher. (if you switchit by mouse it will work fine..)

But ok if it works now by you dont touch it :P

My engines are starting in a complete other way so i dont have to deal with this problem only have try to help you out... (not bad a airbus builder is helping a 737 )

.....

A fuel engine warning led .. YES i have many leds .. the whole overhead is full of it :P so i have a faulure led on each tank ( left,right, middle ect ect.) But to be clear i dont use offsets of FS for this but i am working with 2 different progs for this now one is the A320 AST software and the other one is PMsystems and they work on a complete other way and without there software you cant use it.

So i am not sure how it is with the FS bus if you goto the PM page (www.projectmagenta.com) and goto docs you can see the whole offset list of Peter Downson there and iam sure he also have a offset for that kind of things...

gr.

Frans M
www.airbus320.nl