Ready for Pushback2 Triebwerksstart

[ThomasT]

Ansonsten versuch mal folgendes:

Main Battery ON E-Panel
Electric Pump HYD SYS 4 ON H-Panel
Grd Crew Call EXT. PWR O-Panel
Ext Pwr 1+2 ILLUM. AFTER 1/2 MINUTES E-Panel
Grd Serv 1+2 CLOSED E-Panel
Bus Tie Switches 1-4 CLOSED E-Panel

Crossfeed Valve Main 2 OPEN F-Panel
Boost Pumps Main 2 ON F-Panel

APU switch ON E-Panel
APU Door Lights OFF E-Panel
APU switch START E-Panel
APU 100% E-Panel
APU Gen Switches 1+2 CLOSED E-Panel
Grd Crew Call DISCON. EXT. PWR O-Panel
APU Bleed Air Valve OPEN E-Panel

Set FFRAPS Radio Panel
Set EPR A/T-MODE Radio Panel
Toggle EPR switch to required EPR Radio Panel
Set Speed Bugs Main-Panel

Set Bleed Air H-Panel
All Valves OPEN H-Panel
Pack Valves CLOSED H-Panel
Set Fuel Panel START SEQ. F-Panel

Push Back
Beacon ON O-Panel

Ingnition switch 4 ON O-Panel
N2 at 20% No.4 O-Panel
Fuel Valve No.4 OPEN Throttle-Panel
Start Seq. 4-1-2-3

Thomas