The elevator (horizontal stabilizer) shows all the way up or down when viewed in spot-view
When you switch over from autopilot to manual flying, you should disengage the a/p completely by pressing the AP DISC bar on the glare shield. Not doing so will have the a/p to maintain control over your ALT-setting which causes your trim to adjust the elevator to hold your altitude level when you push/pull the yoke. Or use trim adjustments to correct.
After you pressed the AP DISC bar, you can than select A/T again if you wish to have the a/p maintain control over your speed
das habe ich erhalten.
____________________________________
mfg
hermann
|