Elevator-Trimmung bei PROJECT-Fokker

hermann_DIA041 · 19.02.2003, 11:54

The elevator (horizontal stabilizer) shows all the way up or down when viewed in spot-view

When you switch over from autopilot to manual flying, you should disengage the a/p completely by pressing the AP DISC bar on the glare shield. Not doing so will have the a/p to maintain control over your ALT-setting which causes your trim to adjust the elevator to hold your altitude level when you push/pull the yoke. Or use trim adjustments to correct.
After you pressed the AP DISC bar, you can than select A/T again if you wish to have the a/p maintain control over your speed

das habe ich erhalten.

19.02.2003, 11:54	#3
hermann_DIA041 Jr. Member Registriert seit: 04.01.2003 Alter: 77 Beiträge: 29	The elevator (horizontal stabilizer) shows all the way up or down when viewed in spot-view When you switch over from autopilot to manual flying, you should disengage the a/p completely by pressing the AP DISC bar on the glare shield. Not doing so will have the a/p to maintain control over your ALT-setting which causes your trim to adjust the elevator to hold your altitude level when you push/pull the yoke. Or use trim adjustments to correct. After you pressed the AP DISC bar, you can than select A/T again if you wish to have the a/p maintain control over your speed das habe ich erhalten. ____________________________________ mfg hermann

Aktive Benutzer in diesem Thema: 1 (Registrierte Benutzer: 0, Gäste: 1)