WCM Forum - Einzelnen Beitrag anzeigen

AlTonno · 04.12.2005, 21:11

Hi Jan,

as far as I know, you can only use 4k7 potentiometer - I don't think it will work with 100k's, but I can't tell for sure....

Anyway, if you turn the DIO-Port so, that the 10pin connector of the FSBUS-Cable is top right (soldering side facing down), the sliders are connected to the left pins ("input") of J3. The others are +2,5V (in the middle) and GND (on the right) - these are connected to the two ends of the potmeter.

hope that helps,
seeya, Chris

04.12.2005, 21:11	#2
AlTonno Master Registriert seit: 22.08.2003 Alter: 37 Beiträge: 623	Hi Jan, as far as I know, you can only use 4k7 potentiometer - I don't think it will work with 100k's, but I can't tell for sure.... Anyway, if you turn the DIO-Port so, that the 10pin connector of the FSBUS-Cable is top right (soldering side facing down), the sliders are connected to the left pins ("input") of J3. The others are +2,5V (in the middle) and GND (on the right) - these are connected to the two ends of the potmeter. hope that helps, seeya, Chris ____________________________________ beste grüße, Christopher Haus-Air =) --------------------- w w w . s i m - m o d u l e s . a t [ Avionic Kits for Flight Simulation ] --------------------- VISIT www.HAUS-AIR.at Der einfachste Weg, sich selbst schnell mal ein Cockpit zu basteln...