|
|
|
|
|
|
|||||||
| Home Cockpit - Das Forum für die "Bastler" Cockpitbauer tauschen Pläne, Erfahrungen, Meinungen über den Bau von Homecockpits aus... |
 |
|
|
Themen-Optionen | Ansicht |
|
|
04.12.2005, 21:11
|
#1 |
|
Master
 Registriert seit: 22.08.2003
Alter: 37
Beiträge: 623
|
Hi Jan,
as far as I know, you can only use 4k7 potentiometer - I don't think it will work with 100k's, but I can't tell for sure.... Anyway, if you turn the DIO-Port so, that the 10pin connector of the FSBUS-Cable is top right (soldering side facing down), the sliders are connected to the left pins ("input") of J3. The others are +2,5V (in the middle) and GND (on the right) - these are connected to the two ends of the potmeter. hope that helps, seeya, Chris
____________________________________
beste grüße, Christopher Haus-Air =) --------------------- w w w . s i m - m o d u l e s . a t [ Avionic Kits for Flight Simulation ] --------------------- VISIT www.HAUS-AIR.at Der einfachste Weg, sich selbst schnell mal ein Cockpit zu basteln... |
|
|
|
| Aktive Benutzer in diesem Thema: 1 (Registrierte Benutzer: 0, Gäste: 1) | |
|
|
Hybrid-Darstellung
