Fsdisplay and Project magenta

[Jan 737]

Hi fsbussers,

I've a question, when i'm trying to setup for example the altitude with a ddm 427 rotary and the project magenta software i get odd values back from fs bus.Setup the course for example with the standard fs works good.
Is this a fault in the fsbus or.....

Regards Jan

[dirkan]

Hi,

i am still working on the pm things. Please wait a few days.

kind regards Dirk

[Mathew]

Hi Jan,

which rotarys are you using ? The "Conrad" with Redec PCB ???

Mathias

[Jan 737]

Yes the ddm 427 with the redec09b.

[pmartin]

hello everybody!
I build this pcb to!
But i found a problem!
You can only connect on every section 0-1-2-3-4-5-6-7 one of this switches! Then it works!
Let me explain it on a an expample:
1. switch on Pin 01-02
2. switch on Pin 11-12
3. switch on Pin 21-22

ok? ;-)
i hope i explain it correct and you understand! And it works on my FSBus and Display!

best wishes from the great sahara in the noth of the alps (germany)

peter

[Mathew]

@ Jan737
@ PMartin

can you rotate the rotarys real fast ??? or do you have to turn CAREFUL ?

Thanks

Mathias

[Jan 737]

To Peter:

I don't understand what you mean, are you using the ddm427 and the redec also?

To Mathias:

Yes, you can. i tryed it with the course and it's works great.
Also fine for the com and nav. radio's

Regards Jan.

[pmartin]

i use knitter-switch and ddm427
and i do it very quick!
You have groups of pins (1-7) and you can only connect on every group of pins a switch!
Did you now understand what i mean?

grettings peter

[Jan 737]

Yes Peter Thanks

Regards Jan