Chello mag meinen 3 Com AP nicht

[supercracy]

Hallo Leute

Habe ein riesiges Problem. Zu Weihnachten schneite ein 3 Com Access Point 2000 zu mir. Verbindung mit meinem Laptop Kein Problem, aber bekomme keine Verbindung mit dem Chellomodem. MAC Adresse hab ich schon ändern lassen, aber nichts!!! Was soll ich tun?? Die von Chello wollen mir nicht helfen. Hab nur ein Laptop, brauch ich da vieleicht einen Router.

Bin für jeden Tip dankbar.
Ciao

[valo]

du hast die mac adresse vom kabelanschluss bei chello registriern lassen? kannst du am accesspoint die ip einstellen? kann der access point DHCP? wenn nicht, dann muss du die ip fix eintragen... dazu mustst bei chello anrufen und nach der ip für die MAC adresse fragen und dann in den accesspoint eintragen...

[supercracy]

Hatte vorher Direktverbindung mit Chello über RJ 45 war alles ok
Hab die MAC Adresse vom AP eintragen lassen
Kann den AP nur über Browser konfigurieren, wenn ich die IP Adresse ändere hab ich keine verbindung zum AP mehr

Hier ein paar Auszüge aus der User Guid vielleicht kann wer damit was anfangen


Obtain an IP address automatically (Used if a DHCP server is available. If a DHCP server does not assign it an IP address, the access point's default IP address is 169.254.xxx.1, where xxx is the last byte of the access point's MAC address))

Ethernet connection
At the RJ45 Ethernet connector
On--Unit has an Ethernet connection.
Off--Unit does not have an Ethernet connection.
Blinking--Wired LAN traffic is detected. Faster blinking indicates heavier traffic

Access Point Network
This setting allows you to change the IP address of the access point.

To let the access point get an IP address automatically, click Obtain an IP address automatically and click Save.

To specify an IP address, click Specify an IP address, enter the IP address parameters in the spaces provided, and click Save.

If you change the IP address, you cannot continue to configure the access point using the old IP address. Therefore, if you want to continue configuring this access point after you save this change, you must do the following:


When you specify an IP address, the access point cannot act as a DHCP server. Make sure that clients are using IP addresses on the same network.
Wireless DHCP Server
If your wired network has a DHCP server, it is recommended that you use it. However, the access point provides a DHCP server so that operating systems that do not support automatic IP addressing can communicate with it.



If a DHCP server does not assign it an IP address, the access point's default IP address is 169.254.xxx.1, where xxx is the last byte of the access point's MAC address. When it is acting as a DHCP server, the access point can assign up to 253 IP addresses to currently associated wireless clients. The IP addresses range from 169.254.xxx.2 to 169.254.xxx.254.

If the access point detects that another DHCP server is available, all wireless clients get IP addresses from that DHCP server.

If your wired LAN DHCP server goes down, the access point assigns IP addresses after the lease periods on the previous IP addresses expire.

To let the access point act as a DHCP server when there is no other DHCP server available, click Enable and click Save.

To turn off the access point DHCP server capability regardless of whether or not another DHCP server is available, click Disable and click Save.


Thanks so much