Festplatten werden nicht erkannt

[Karl]

@mascara!
Ins Bios dürftest da überhaupt nicht reinkommen. Da steht was von auto und best performance.

Aber wennst den Treiber installierst sollte da was zu verstellen sein.


Tools and Drivers :

Windows 9x Windows NT 4.0 Windows 2000 Windows Me DOS Linux



Frequently Asked Questions:




VScom serial cards and Linux
Windows 2000
VScom serial cards and OS/2
VScom interfaces and Novell Netware 4.10
Operating VScom PCI cards in DOS


VScom PCI cards in other operating systems
ISA-cards are installed correct, but do not operate
How to replace an RS-232 Connection by RS-422?
ISA-Bus and IRQ-Sharing?
How to operate COM10 to COMxx?


Printer (ZIP, Scanner,...) installation in NT fails with PCI parallel ports?
Windows NT "Cannot read EEPROM"?
TURBO-series, how to install in Windows NT?
PRO-series, operating in Windows 2000



Linux:

There is a new driver for our PCI-series available for download. This driver requires the Kernel version 2.2, it is optimized for the SUSE-Distribution.
In the older Kernel version 2.0 the PCI cards are configured with our tool VSCARDCFG. Just run it, it will establish all necessary settings.
To install ISA-cards, there is a prepared documentation, describing the manual installation of serial ports.




Windows 2000:
The drivers are available in the download area. Known problems:

The PCI boards have two possible speed settings. Installation always assumes high speed. I.e. the maximum baudrate is 921.600bps. Sometimes this is not the real configuration of the board. But for ease of installation the driver does not check the speed while installing.
Please use the "Check" button in the "Advanced" panel of the serial card.
When uninstalling the system sometimes hangs. VS is working on this problem.

P.S. Bin mir jetzt aber nicht sicher was dich betrifft. Weiss nicht genau welche Karte du hast.