INACCESSIBLE_BOOT_DEVICE bei NT setup

Falls FAT16 auch nicht funktioniert, erkennt NT deinen SCSI Controller nicht:


Issue:

During installation an error of INACCESSIBLE_BOOT_DEVICE will occur if the installation is booting from the NT CD.

***STOP: 0x00000078 (0xF9813B7C,0xC00000034,0x00000000,0x00000000)
INACCESSIBLE_BOOT_DEVICE


Resolution:

Press the F6 key when the following message displays:
"Setup is inspecting your computer's hardware configuration"

Pressing the F6 key will allow the installation of the SCSI driver early during the installation. The following message will appear:


Windows NT Setup

Setup could not determine the type of one or more mass storage devices installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage device(s):

...
AMD PCI SCSI Controller/Ethernet Adapter
Bus Logic Flashpoint
Compaq 32-bit Fast-Wide SCSI-2/E
Emulex LP600 Fiber Channel Host Adapters
.
.
.


* To specify additional SCSI adapters, CD-ROM drivers, or special disk controllers for use with NT, including those for which you have a device support disk from a mass storage device manufacturer, press S

* If you do not have any support disks from a mass storage device manufacturer, or do not want to specify additional mass storage devices for use with Windows NT, press ENTER

Press S
Choose Other
Insert the SCSI drivers disk with the Windows NT driver
Select driver
Continue with the installation

Hast du einen ASUS PCI-SC200 PCI SCSI Controller ? ASUS SCSI-Treiber auf http://www.asuscom.de/products/addon...silan_drv.html