fsbus Ansteuerungsproblem

rvdijk · 31.03.2007, 08:46

There are two types af Hardware for FSBUS:

- The Classic types with the PIC Microcontrollers.

This type of hardware is not serviced anymore!

- The NG (New generation) types with the Atmels

In the NG types there was only one important modification made on the IO cards ... that is Jumper 16!
This was done on the eind of 2005. If you have a PCB without this Jumper I advise you to modify the PCB with that Jumper (easy to do with a 'Home Builded' Card). The jumper must be set during configuration with FSADMIN!

All NG harware is compatible with the upcoming FSBUS CDK software!

The DO64 PCB (64 Led's) is only compatible with the new software!

regards,
Rob

31.03.2007, 08:46	#1
rvdijk Newbie Registriert seit: 28.12.2005 Beiträge: 16	FSBUS Compatible ... There are two types af Hardware for FSBUS: - The Classic types with the PIC Microcontrollers. This type of hardware is not serviced anymore! - The NG (New generation) types with the Atmels In the NG types there was only one important modification made on the IO cards ... that is Jumper 16! This was done on the eind of 2005. If you have a PCB without this Jumper I advise you to modify the PCB with that Jumper (easy to do with a 'Home Builded' Card). The jumper must be set during configuration with FSADMIN! All NG harware is compatible with the upcoming FSBUS CDK software! The DO64 PCB (64 Led's) is only compatible with the new software! regards, Rob

Aktive Benutzer in diesem Thema: 1 (Registrierte Benutzer: 0, Gäste: 1)