usb verbindung zw. 2 rechnern, wie mach ichs?

[mcs_]

< Processor(s) >
Processor(s): Intel Pentium III @ 1.00GHz
Performance Rating: PR1201 (estimated)
L2 On-board Cache: 256kB ECC synchronous ATC

< Mainboard and BIOS >
Bus(es): ISA AGP PCI USB SMBus/i2c
Multi-Processor Support: No
System BIOS: Award Software International, Inc. 6.00 PG
System Chipset: VIA Technologies Inc VT82C691/693A/694X Apollo Pro/
133/133A System Controller
Installed Memory: 512MB (34% true allocated load)


Serial/Parallel Port(s): 3 COM / 1 LPT
USB Controller/Hub: VIA Tech 3038 PCI-zu-USB Universeller Host Controller
USB Controller/Hub: VIA Tech 3038 PCI-zu-USB Universeller Host Controller
USB Controller/Hub: USB-Stammhub
USB Controller/Hub: USB-Stammhub

Windows System: Microsoft Windows Me Ver 4.90.3000
DOS Sub-System: Microsoft MS-DOS Ver 8.00 A

< Network Adapter(s) >
Networking Installed: Yes
Adapter: DFÜ-Adapter
Adapter: Microsoft virtuelle lokale Netzwerkkarte
Adapter: GeneLink Network Adapter
Adapter: 3Com EtherLink XL PCI TPO NIC (3C900B-TPO)

Manufacturer: VIA Technologies, Inc.
Model: VT82C694X

Manufacturer: Micro-Star
Model: W6318M7 V1.9 092800 NETWORK


< USB Bus(es) >
Model: VIA Technologies Inc VT83C572,VT82C586/A/B,VT82C596B,
VT82C686A USB Controller
Version: 1.10
UHCI Interface: Yes
Channels: 2
Bus Speed: 48MHz
Legacy Emulation Enabled: No

<< VIA Tech 3038 PCI-zu-USB Universeller Host Controller >>
< General Information >
Controller: VIA Tech 3038 PCI-zu-USB Universeller Host Controller

< Root Hub Information >
Compound Device: No
Hub Is Bus Powered: No
Power Switching: None
Over-current Protection: None
Number of Ports: 2

< USB Port 1 >
Status: No Device Connected

< USB Port 2 >
Status: Device Connected
Connected Device: GeneLink USB Adapter
Device Version: 1.81
Device Hardware ID: VEN_05E3, DEV_0502, PRT_00
USB Version: 1.00
Full Speed Device: Yes
Open Pipes: 3
Transfer Type: Bulk
Max. Packet Size: 8 bytes



.... so, jetzt ist aber wohl alles drin ...