Frage zu FSBUS AD Controller

Jan 737 · 17.11.2005, 19:47

Hello Stefan,

Read the doc's and you should see that the CID must be CID 4 for the Ad board.

On the 3 pins you connect a potmeter (100k lin).
How? there is a picture in the manual.
You can meassure with a Ohm meter how to connect.Most of the times you will meassure aprox. 100k on the both outside pins.
The middle one is the slider and will give a value between 0 and 100k when you meassure between the middle and one outside pin.

After that you connect the potmeter go to the router and add a Analog input, set the CID and Row id.Set the max.value on 16384 and the min.value on 0.Set the destination to the flaps lever.
When you move the flaps lever you see change the value in the current value box.

Good luck

Jan

17.11.2005, 19:47	#2
Jan 737 Senior Member Registriert seit: 03.04.2003 Alter: 65 Beiträge: 113	Hello Stefan, Read the doc's and you should see that the CID must be CID 4 for the Ad board. On the 3 pins you connect a potmeter (100k lin). How? there is a picture in the manual. You can meassure with a Ohm meter how to connect.Most of the times you will meassure aprox. 100k on the both outside pins. The middle one is the slider and will give a value between 0 and 100k when you meassure between the middle and one outside pin. After that you connect the potmeter go to the router and add a Analog input, set the CID and Row id.Set the max.value on 16384 and the min.value on 0.Set the destination to the flaps lever. When you move the flaps lever you see change the value in the current value box. Good luck Jan

Aktive Benutzer in diesem Thema: 1 (Registrierte Benutzer: 0, Gäste: 1)