Digitus DN 7011

[DocHofa]

Mach nocheinmal einen Reset nach einem der folgenden Verfahren (aus dem Manual):

Reset to factory Default

There are 3 methods to reset to default.

1. Restore with console mode

Please notice that this method requires a null modem cable and terminal program (e.g. HyperTerminal for
Windows). First, configure the setting of your terminal program as 19200 N-8-1. And then, power off and on
router. When “AT” prompt is appeared, press, “ENTER” once to show the console mode commands. Just type
“RR” command to restore the factory setting. Please refer to User Manual for the details.

2. Restore with RESET button

First, turn off the router and press the RESET button in. And then, power on the router and hold the RESET button
down until the M1 and or M2 LED (or Status LED) start flashing, then move away the hand. If LED flashes about
8 times, the RESTORE process is completed. However, if LED flashes 2 times, repeat.

3. Restore directly when the router power on

First, hold the RESET button about 5 seconds (M1 will start flashing about 5 times), move away the
hand. The RESTORE process is completed.

Jetzt sollte alles wieder wie bei Auslieferung des Routers sein - ansonsten stellt sich die Frage, ob das Gerät nicht defekt ist.

DocHofa