FSIF.ini Konfiguration

[bwr014]

Hi Tomker,

The offsets of PMsystems you cant find in PMsystem software itself. If you put the software in that way that is show you the offsets when you go with your mouse over it you can see what is what...

The way it is build you have to see if it is a Byte or a BIT like that you can see in the ini file of Fsbus how PM is build up...

I still have to make a INI file as well for PMsystem i already did make it for AST. But if you look to the way it is build now you maybe can try it yourself as well.. just pay attention that one time it are BIT 0,1,2,3,4,5 ect and other time it is a BYTE... i think they all are 16I and some are only W=write some are only R=read and others are both again RW..

You start with a :

Subgroep like 0,PMsystems then under that you can make a new group again that will start with a 1, BATT1 ON ect..

I would advice to make a seperate group for all the leds..

If i have some time i will try to see if i can also make the ini file for PMsystem

gr.
Frans M