Mehrer AccessPoints im Netzwerk

[justsmile]

Mein Netgear WG602 meint dazu

Access Point Mode

Access Point
Operate as a standard 802.11g or 802.11b Access Point. In this mode, the WG602v2 will communicate with wireless clients only.

Wireless Point-to-Point Bridging
In this mode, the WG602v2 will communicate with a single bridge-mode wireless access point. And, if you check the Enable Wireless Client Association checkbox, wireless clients will also be serviced by this access point. You must enter the MAC address (physical address) of the other Bridge-mode Wireless Station in the field provided. WEP can (and should) be used to protect this communication.

Wireless Multi-Point Bridging
In this mode, the WG602v2 will communicate with up to four bridge-mode wireless access points. And, if you check the Enable Wireless Client Association checkbox, wireless clients will also be serviced by this access point. You must enter the MAC address (physical address) of each other Bridge-mode Wireless Station in the field provided. Each wireless access point you enter will be listed in the Wireless Remote Access Point List. When you enter the remote wireless access point MAC address, the WG602v2 will attempt to validate that the SSIS, channel, and WEP configuration of the remote access point matches the settings of this WG602. WEP can (and should) be used to protect this traffic.

Repeater
In this mode, the WG602v2 will operate as a Repeater only, and send all traffic to the remote AP. If selected, you must enter the MAC address (physical address) of the remote AP.


Hoffe das hilft!