HCSDT - Software auf 2 Rechner verteilt?

[bwr014]

Hello Peter,

I am not sure if i understand your question correct but looking at your drawing i think you going to get a problem at your fusi3 where you want to run PM standby + PM cdu + HCSTD ecam this is much to much on one comp. You need a seperate computer for the PMcdu or you going to proformance problems. I think also the same with your combination of PM AGBC + OHL on one comp....

Beter is i think to have one maincomp for your FS200X + FSbus + PM FCU + FScommunicator + Nav + HOSTSB 2e comp AGBC PM /ND 3e comp HCSTD Ecam + AGBC standby 4e comp PM MCDU + OHL (where the CDU will need a seperate 5 inch lcd connected)

This is a bit how i have the situation now.

I dont know how you controle now your padels and throttle and sticks but if you going to use FScommunicator it will also work with direct input to FSUIPC on the buttons ect when you have it on your main comp

But ones again i am sorry if i didnt understand your question correct.

gr.

Frans M