Problem mit zusätzlichen IDE Controller

[Crazy-Crosshair]

ja genau das alles hab ich schon probiert

1) anderes Kabel
2) andere Platte
3) anders gejumpert
4) anderen PCI Slot

aber es geht noch immer nicht *grr*

any help out there ?

Original geschrieben von exacta
@valo:
bei der ultra-serie is nix mit raid, ist nur ein stinknormaler pnp ide controller;


Q:What does it mean when I boot the system and the Ultra controller says, ´´BIOS Not Installed´´?
A:Solution: No Hard Drives are being detected at the Ultra Bios Posting. Check cables, jumpers, power connectors and lastly check drives to insure they are detected on a standard hard disk controller.


Q:Why is my Hard Drive not seen?, Why do I get the message ´´BIOS Not Installed´´, What is my CMOS Configuration?
Cause: Hard Drive Jumper Settings, Cable Issues, CMOS Configuration, BIOS Version, PCI 2.1 Compliancy, No Hard Drives attached to Ultra100 Card.


Solution: The only reason that the Ultra100 BIOS will not install is if it doesn´t detect a HDD. If you don´t have a HDD connected to our card, connect one. If you do, check the HDD jumper settings and cabling. If your HDD is from WD, and it´s the only device on the cable, remove ALL the jumpers from the HDD. If the problem still exists, contact tech support with the following information. What are the HDDs that you´re using with the Ultra100? What is the jumper setting on each HDD? What is the version of the BIOS on the Ultra100? Make sure the HDDs on the Ultra100 are defined as ´´None´´ or ´´Not Installed´´ in the CMOS. Are the cables that you´re using with the Ultra100 18´´ or less?

******Try switching the PCI slot that the Ultra100 is in.******

Try resetting the configuration data in the CMOS. This is usually an option in the PnP section of the CMOS. The only available settings for this option will be ´´Enabled´´ and ´´Disabled´´. Set it to ´´Enabled´´, save and exit, and reboot.

mfG,
exacta