Fsbus

[bwr014]

Hi as promised here the part you need to put into your fsif.ini file to get the PM ecam select buttons to work with FSbus.

0, "PMSYSTEMS ECAM SELECT"
1, "ENG", 600, 0, 0x552C, I32,,RW ,10,1,1,
1, "BLEED", 601, 0, 0x552C, I32,,RW ,10,1,2,
1, "PRESS", 602, 0, 0x552C, I32,,RW ,10,1,3,
1, "ELEC", 603, 0, 0x552C, I32,,RW ,10,1,4,
1, "HYD", 604, 0, 0x552C, I32,,RW ,10,1,5,
1, "FUEL", 605, 0, 0x552C, I32,,RW ,10,1,6,
1, "APU", 606, 0, 0x552C, I32,,RW ,10,1,7,
1, "COND", 607, 0, 0x552C, I32,,RW ,10,1,8,
1, "DOOR", 608, 0, 0x552C, I32,,RW ,10,1,9,
1, "WHEEL", 609, 0, 0x552C, I32,,RW ,10,1,10,
1, "F/CTL", 610, 0, 0x552C, I32,,RW ,10,1,11,

Just pay attention to the numbers 600 until 610 that they not already used by you then change them to a unic number.

After that startup your fsrouter and make a button then at option to it by select the dropdownlist. You will see then a subject PMSYSTEMS ECAM SELECT open that one and you see each button standing. Choose 1 and hit OK.

Make sure your down value is 1 and up value is 0

Then you can test the button when running the FS and PM ABGC + Lower ecam running.

Have tested it here with and without PMsystems and works fine.

succes

gr.

Frans M