Posky A333

[Jim Phelps]

Hi,

Ich habe mir die posky_a333v2_vc von avsim geladen und unter aircraft so installiert. Das ist glaube ich nicht richtig, da die keine Aircraft.cfg bei ist und die install lediglich das enthält:
Project Opensky A330-300 Version 2 with VC installation instructions
To install:

There are seven models for the A330-300. GE, RR, and PW. Each with a satcom antenna and no satcom antenna version. The satcom antenna is the bump on top of the fuselage towards the front passenger door. NOTE: For US Airways and Northwest Airlines, use the satcom2 mdl file

Simply unzip the appropriate model directory(s) into your POSKY A333 V2 folder

For example, if you want the A333 RR version... you would unzip the model.RRvcnosat and model.RRvcsatcom into the directory of your A333 RR files.

Note that if you want to use all seven versions, make sure they are in the appropriate directory. AKA You CAN NOT have the GE version in the RR directory.

In order to use the VC version, you must specify what model to use in the aircraft.cfg folder.

FOR EXAMPLE in the aircraft.cfg heading:

[fltsim.0]
title=Project Opensky - Airbus A330-300GE No Satcom VERSION 2 House livery
sim=A330-300-GE-CF6-80E1
model= gevcnosat
panel=
sound=
texture=
checklists=

The 'model' section has " gevcnosat " written to tell FS what model to use for that livery.

NEXT, copy the panel folder and overwrite your current panel folder. Overwrite any files when prompted.

FOR BETTER FRAMES: rename the panel747nd.cfg file to panel.cfg This will replace the Airbus ND gauges with the 747 ND and give you better frames.

Copy the modules and gauge directory files into your respective FS folder.


FINALLY, copy the VC textures into the texture directory of the plane you want


POSKY TEAM.

Gibt es da ein Basicpacket und was muss ich tun?

Gruß Marcus