![]() |
![]() |
|
![]() |
![]() |
|
Home Cockpit - Das Forum für die "Bastler" Cockpitbauer tauschen Pläne, Erfahrungen, Meinungen über den Bau von Homecockpits aus... |
![]() |
|
Themen-Optionen | Ansicht |
![]() |
#1 |
Newbie
![]() Registriert seit: 25.08.2003
Beiträge: 2
|
![]() Hi all,
I am totally new on this forum, so this is my first posting. After visiting the Dutch simcockpit forum, I'm also gonna building my cockpit using FSBUS. That's where goes my small question about, for the connectors I am using a 'STIFTLEISTE'. Now I want to connect a switch with the connector but which female connector do I need to use with a 'STIFTLEISTE' ![]() ![]() I know the connectors from my computer to connect the power switch and the hard disk LED with the mainboard. Does anybody know where I can buy those type of connectors in Germany ??? Thanks for any advice... Sincerly Gijs |
![]() |
![]() |
![]() |
#2 |
Jr. Member
![]() Registriert seit: 17.06.2003
Alter: 62
Beiträge: 93
|
![]() Hi,
please look for this thread http://www.wcm.at/vb2/showthread.php...readid=107376. There you will find an Excelfile with all FSBUS parts to be ordered at www.Reichelt.de. Its called Bauteileliste.zip When you open this list, you will find under "Bestellnummer/ Link" a link for each part which will lead to the appendant page at www.reichelt.de, provided that you are logged on into the internet. On "Stiftleiste" you can use "Pfostenbuchse" to be clamped on to ribbon cable. "Pfostenbuchse" fit´s onto "Stiftleiste" ![]() Regards Thomas |
![]() |
![]() |
![]() |
#3 |
Newbie
![]() Registriert seit: 25.08.2003
Beiträge: 2
|
![]() Hi...
Problem with the 'Pfostenbuchse' is too big what I need. My LED has for example 2 wires, and those need to be connected to FSLED board. A 'Pfostenbuchse' would be too big and I can't connect all LEDs to one connector, got them everywhere... What I exactly looking for is this one of Conrad, only then a version without the wire and much cheeper. To pay €1.60 for one connector with a very short wire is not what I am looking for, need approx. 150 of them... ![]() Sincerly Gijs |
![]() |
![]() |
![]() |
#4 |
Master
![]() Registriert seit: 14.02.2002
Alter: 66
Beiträge: 644
|
![]() Hi,
"Pfostenbuchse" is avilable with 20 or 40 pins. There are special ones, which can be broken to whatever you want. A 40 pin gives 20 cheap connectors for LED's. If you can't find these breakable "Pfostenbuchse", you may break the ordinary and loose 1 pin. You get 13 LED connectors out of a 40 pin Pfostenstecker. What is the correct englich word for it ? kind regards Dirk |
![]() |
![]() |
![]() |
#5 |
Hero
![]() Registriert seit: 10.12.2000
Beiträge: 962
|
![]() Hi,
Pfostenstecker = Postplug Pfosten = wie senkrechter Balken = Post Stecker = Plug ULI
____________________________________
Wenn ich nen Tip gebe für XYZ, dann hat das nichts mit Werbung zu tun. |
![]() |
![]() |
![]() |
Aktive Benutzer in diesem Thema: 1 (Registrierte Benutzer: 0, Gäste: 1) | |
|
|