Um keinen Blödsinn zu kaufen....

[Achilles]

Hallo Profis!

Ich möchte eine Schaltung mit folgenden Bauteilen basteln, bin mir aber bei einigen Parts nicht sicher ob der deutschen Namen. Um keinen Blödsinn zu besorgen, bitte folgende Liste ins "Deutsche" zu übersetzen. Vielen Dank im Voraus!

............
1 X D Connector 9 Pin Female Solder.

6 X 0.1uf 50V Ceramic capacitor or equivalent value; 100nF, 100,000pF or EIA code 104. [used for C1, C2, C3, C4, C5 and near eeprom in unsoldered read]

Please NOTE: if you can only obtain the HIN232, you will need to use 1.0uF capacitors for C2, C3, C4 and C5 as the 0.1uF capacitor will NOT work with the HIN232.

3 X 4700 ohm resistor 0.25W 5% [used for R1, R2, R3]

1 X 330 ohm resistor 0.25W 5% [used for 4]

4 x Diode 1N4148 or 1N914 [used for D1, D2, D3, D4]

1 X MAX232A or ICL232 or HIN232 or ST232 IC DUAL RS232 TXCVR 16 Pin DIL [used for U1], try to obtain the A part [MAX232A rather than MAX232] that will work with 0.1uF capacitors, although I have found that non A parts will work just as well, I have only tried MAXIM brand, I don't know about the other brands.

Please NOTE: if you can only obtain the HIN232, you will need to use 1.0uF capacitors for C2, C3, C4 and C5 as the 0.1uF capacitor will NOT work with the HIN232.

1 X Small single pole switch [used for SW1]

1 X Light emitting diode [used for LED1]

1 X Prototyping breadboard also wire to connect components, single strand copper wire, supplied with prototyping board usually.

1 x PC Serial Cable with MALE DB9 connector at interface end DO NOT USE A "NULL MODEM CABLE" this cable has to be a standard serial cable with a 1 to 1 relationship between pins at either end of cable, NOT crossed over as they are in a "NULL MODEM" cable.

1 X small quantity 0.18mm enamel coated wired [for soldering to eeprom pins] this can also be sourced from an old small transformer or coil. The wire needs to be this small diameter to avoid shorting together adjacent pins on eeprom, and also the flexibility of the fine wire will avoid placing twisting forces on eeprom pins and will avoid breaking pins on eeprom.

1 X Battery holder 3 AA or [1 AA + 2 AA wired in series] [used for BT1, BT2, BT3]

You will also need some stiff copper wire to make the connections on the prototyping board and possible a plug and socket to use between the interface and the eeprom or ThinkPad during eeprom analysis.

Important: Make sure IC [MAX232 OR EQUIV] is a DIP [Dual Inline Pin] and not SMD [Surface Mount Device]

.........

PS: bin leider kein geübter Elekroniker, deswegen ein bisserl überfordert!

Danke
Achi