Watch out for mirror platinen (PCB)

[PA7RM]

Inside the ZIP file of FsServo is the component side a wrong picture (FsServo.JPG) it is mirrored. So i have now the wrong PCB. I think the maker of my PCB had used that file. Also my display's PCB are mirrored. He also used the wrong layout. I was checking the Decimal Point. Hmmm. Funny... Not good. At least the COM platine is allright so i can go further with the project, with a small delay. I will check the pictures on my website. Thanks to the website of the Fins guy's i discovered it before soldering. So advise: always check before, and double check, just like the preflight.