HELP with FSDISP and 7digs.....

[bwr014]

Hello ULI,

(bwr = frans)

Let me try to explain it again... on the fsbus site and i am sure you know the links you can find the pcb layout for the 7 digs ( the 3 and 5 version)

I made those pcb's i got from mathias the correct 7 digs i needed to buy by conrad ( 15 inch i believe) and solder them on the 3 version pcb ... grab the cable that is conected to the fsdisp board and conected the pcb i made as mention to do on the FSbus site to that conector... and as i already had somany times before... the leds didnt show the result or at least some parts of the leds light up or the point light up at least nothing in the way it should be.

And just for your information the pcb's on the FSbus site ARE the CORRECT size for the FDS panels of the FCU.

Mathias made me a set ( not even close looking to the FSbus version) and those leds are much to small....

SO i have now the correct size leds with pins on top and bottom of the led and now i am really hoping that someone will give me the correct PCB layout to make the correct pbc to get mine 7 digs i have laying here and that i needed to buy comform mathias to work with the fsdisp i have here... meening plug and play... so no figure out if the pins are correct just like i got them before from mathias but now for the led size i have here!

And i just will be happy if i can get a set of 3 working ....

I assum i am not the first one that is going to do this so any help in this would be appricate...

gr.

Frans
BWR014

www.planesonline.nl