FSBUS NG 7Seg Probleme

Jan 737 · 16.02.2006, 17:52

Hi,

Same problem overhere.
Flashed the Attiny CC with the disp_tiny_cc file(date 28-08-2005)without problems.
Set in fsadmin the CID to 1.
Adjust the brightness and played around with the sliders to display some numbers.All without problems.

Disconnect the jumper on the sixpack and close fsadmin.

Start the router software and route CID 1 to the NAV1 freq.
All what's happens the display stay dark.

Downloaded the zip file fsbus2_4_1.zip and installed the software again.
Couldn't find the right firmware for the Attiny2313 CC.

When disconnecting and connecting the 10 pin flatcable to the sixpack pcb the number 1 digit shows 1 for a short while.

What I'm doing wrong????????

Best regards

Jan Geurtsen

16.02.2006, 17:52	#1
Jan 737 Senior Member Registriert seit: 03.04.2003 Alter: 65 Beiträge: 113	Display stay dark Hi, Same problem overhere. Flashed the Attiny CC with the disp_tiny_cc file(date 28-08-2005)without problems. Set in fsadmin the CID to 1. Adjust the brightness and played around with the sliders to display some numbers.All without problems. Disconnect the jumper on the sixpack and close fsadmin. Start the router software and route CID 1 to the NAV1 freq. All what's happens the display stay dark. Downloaded the zip file fsbus2_4_1.zip and installed the software again. Couldn't find the right firmware for the Attiny2313 CC. When disconnecting and connecting the 10 pin flatcable to the sixpack pcb the number 1 digit shows 1 for a short while. What I'm doing wrong???????? Best regards Jan Geurtsen

Aktive Benutzer in diesem Thema: 1 (Registrierte Benutzer: 0, Gäste: 1)