WCM Forum - Einzelnen Beitrag anzeigen - Wow,Performance-Steigerung....via....

uli2 · 02.03.2003, 03:28

Hi,
anbei mal ein paar Einstellungen due bei meinem System eine Steigerung von plus 15 Frames gebracht hat.
Teilweise springt die Anzeige auf 100 Frames....tszzzz...
Allerdings hab ich den Vergleich jetzt erstmal bei FS2000 getätigt.
Ich denke aber das daß auch beim FS2002 positive Auswirkungen hat, denn es handelt sich hier um BIOS-Einstellungen.
Ich benutze zur Zeit auch den neusten Nvidia Treiber für XP.
Anbei die Einstellungen, ohne Garantie.
Gruß ULI

PERFORMANCE BIOS SETTINGS

Use this settings in your BIOS along with the OMEGA drivers to get the best performance possible out of your video card (this settings are not avaiable in all motherboards, use only the ones that fit your BIOS):

Fast Gate A20 Option : ENABLED
Video BIOS shadowing : DISABLED
Video BIOS cacheable : DISABLED
xxxxx - xxxxx Shadow : ALL DISABLED
IDE prefetch mode : ENABLED
Init Display First : AGP or PCI (SELECT YOUR CARD TYPE)
IDE HDD Block Mode : ENABLED
IDE 32-bit transfer mode : ENABLED
Assign IRQ for USB : DISABLED (UNLESS YOU USE USB DEVICES)
Assign IRQ for VGA : ENABLED
PCI/VGA palette snoop : DISABLED
PNP OS Installed : ENABLED (UNLESS YOU WANT TO MANUALLY ASSIGN IRQ's)
Resource Controlled By : AUTO (UNLESS YOU WANT TO MANUALLY ASSIGN IRQs AND DMAs)
AGP aperture size : 128
AGP master 1 WS write : ENABLED***
AGP master 1 WS read : ENABLED***
Bank 0/1, 2/3 DRAM timing : TURBO***
CPU to PCI write buffer : ENABLED
Delayed Transaction : ENABLED
DRAM speculative leadoff : ENABLED***
DRAM Data Integrity Mode : NON-ECC (UNLESS YOU HAVE ECC MEMORY)
Delay DRAM read latch : (THE LOWER, THE FASTER)***
Fast writes : DISABLED
Memory parity/ECC check : DISABLED***
Passive Release : ENABLED
PCI Concurrency : ENABLED
PCI master 0 WS write : ENABLED***
RAS active time : (THE LOWER, THE FASTER)***
RAS to CAS delay : (THE LOWER, THE FASTER)**
Read around write : ENABLED
SDRAM Bank Interleave : 4-bank/way
SDRAM CAS Latency Time : 2**
SDRAM cycle length : 2**
SDRAM Precharge control : ENABLED
Spread spectrum (modulation): DISABLED
System BIOS cacheable : DISABLED
Video RAM cacheable : DISABLED
8 bit I/O Recovery Time : 1
16 bit I/O Recovery Time : 1
Turbo frequency : ENABLED

** = ONLY IF YOUR MEMORY SUPPORT IT, OTHERWISE USE THE NEXT
HIGHER VALUE

*** = WILL IMPROVE SPEED BUT DECREASES STABILITY, IF YOU HAVE
PROBLEMS CHANGE IT

Well, that's all for the BIOS.
This settings should increase you framerates with your video card, if you want do a benchmark before and after the changes, it will give you a good idea of the gain obtained.

Good Luck!

02.03.2003, 03:28	#1
uli2 Hero Registriert seit: 10.12.2000 Beiträge: 962	Wow,Performance-Steigerung....via.... Hi, anbei mal ein paar Einstellungen due bei meinem System eine Steigerung von plus 15 Frames gebracht hat. Teilweise springt die Anzeige auf 100 Frames....tszzzz... Allerdings hab ich den Vergleich jetzt erstmal bei FS2000 getätigt. Ich denke aber das daß auch beim FS2002 positive Auswirkungen hat, denn es handelt sich hier um BIOS-Einstellungen. Ich benutze zur Zeit auch den neusten Nvidia Treiber für XP. Anbei die Einstellungen, ohne Garantie. Gruß ULI PERFORMANCE BIOS SETTINGS Use this settings in your BIOS along with the OMEGA drivers to get the best performance possible out of your video card (this settings are not avaiable in all motherboards, use only the ones that fit your BIOS): Fast Gate A20 Option : ENABLED Video BIOS shadowing : DISABLED Video BIOS cacheable : DISABLED xxxxx - xxxxx Shadow : ALL DISABLED IDE prefetch mode : ENABLED Init Display First : AGP or PCI (SELECT YOUR CARD TYPE) IDE HDD Block Mode : ENABLED IDE 32-bit transfer mode : ENABLED Assign IRQ for USB : DISABLED (UNLESS YOU USE USB DEVICES) Assign IRQ for VGA : ENABLED PCI/VGA palette snoop : DISABLED PNP OS Installed : ENABLED (UNLESS YOU WANT TO MANUALLY ASSIGN IRQ's) Resource Controlled By : AUTO (UNLESS YOU WANT TO MANUALLY ASSIGN IRQs AND DMAs) AGP aperture size : 128 AGP master 1 WS write : ENABLED* AGP master 1 WS read : ENABLED* Bank 0/1, 2/3 DRAM timing : TURBO* CPU to PCI write buffer : ENABLED Delayed Transaction : ENABLED DRAM speculative leadoff : ENABLED* DRAM Data Integrity Mode : NON-ECC (UNLESS YOU HAVE ECC MEMORY) Delay DRAM read latch : (THE LOWER, THE FASTER)* Fast writes : DISABLED Memory parity/ECC check : DISABLED* Passive Release : ENABLED PCI Concurrency : ENABLED PCI master 0 WS write : ENABLED* RAS active time : (THE LOWER, THE FASTER)* RAS to CAS delay : (THE LOWER, THE FASTER) Read around write : ENABLED SDRAM Bank Interleave : 4-bank/way SDRAM CAS Latency Time : 2 SDRAM cycle length : 2 SDRAM Precharge control : ENABLED Spread spectrum (modulation): DISABLED System BIOS cacheable : DISABLED Video RAM cacheable : DISABLED 8 bit I/O Recovery Time : 1 16 bit I/O Recovery Time : 1 Turbo frequency : ENABLED = ONLY IF YOUR MEMORY SUPPORT IT, OTHERWISE USE THE NEXT HIGHER VALUE *** = WILL IMPROVE SPEED BUT DECREASES STABILITY, IF YOU HAVE PROBLEMS CHANGE IT Well, that's all for the BIOS. This settings should increase you framerates with your video card, if you want do a benchmark before and after the changes, it will give you a good idea of the gain obtained. Good Luck!