eigentlich, ja, aber ich glaube das is standardmässig disabled...
ok, habs grad im installation guide gefunden...
->
http://www.adaptec.com/pdfs/installa...aha2940_ig.pdf
Basic Host Adapter Settings
Default
Host Adapter SCSI ID
7
SCSI Parity Checking
Enabled
Host Adapter SCSI Termination
Automatic '1';
Low ON/High ON '2'
Boot Device Settings
Default
Boot Target ID
0
Boot LUN Number '3'
0
SCSI Device Settings
Default
Initiate Sync Negotiation
Yes (Enabled)
Maximum Sync Transfer Rate
10 MBytes/sec
Enable Disconnection
Yes (Enabled)
Initiate Wide Negotiation '2'
Yes (Enabled)
Send Start Unit SCSI Command '4' No (Disabled)
Advanced Host Adapter Settings
Default
Plug and Play SCAM Support
Disabled
Host Adapter BIOS
Enabled
Support Removable Disks Under BIOS as Fixed Disks '4'
Boot only
Extended BIOS Translation for DOS Drives > 1 GByte '4'
Enabled
Display <Ctrl-A> Message During BIOS Initialization '4'
Enabled
Multiple LUN Support '4'
Disabled
BIOS Support for More Than 2 Drives '4'
Enabled
BIOS Support for Bootable CD-ROM '4'
Enabled
BIOS Support for Int 13 Extensions '4'
Enabled
'1' Applies to AHA-2940 only
'2' Applies to AHA-2940W only
'3' Setting is valid only if Multiple LUN Support is enabled
'4' Settings are valid only if host adapter BIOS is enabled.