[FlusiRainer]

[airplane_geometry]
wing_area=4500.000000
wing_span=197.833333
wing_root_chord=36.000000
wing_dihedral=6.998291
wing_incidence=2.999268
wing_twist=-0.499878
oswald_efficiency_factor=0.999999
wing_winglets_flag=0
wing_sweep=30.000000
wing_pos_apex_lon=0.000000
wing_pos_apex_vert=0.000000
htail_area=925.000000
htail_span=71.416667
htail_pos_lon=-92.833333
htail_pos_vert=0.000000
htail_incidence=0.000000
htail_sweep=0.000000
vtail_area=839.000000
vtail_span=33.025748
vtail_sweep=0.000000
vtail_pos_lon=-85.666667
vtail_pos_vert=5.833333
elevator_area=59.250000
aileron_area=53.040000
rudder_area=43.860000
elevator_up_limit=25.783101
elevator_down_limit=20.053523
aileron_up_limit=17.188734
aileron_down_limit=14.896903
rudder_limit=25.783101
elevator_trim_limit=23.00
spoiler_limit=59.988722
spoilerons_available=0
aileron_to_spoileron_gain=0.000000
min_ailerons_for_spoilerons=0.000000
min_flaps_for_spoilerons=0.000000

[flight_tuning]
cruise_lift_scalar=1.000
parasite_drag_scalar=1.000
induced_drag_scalar=1.500
elevator_effectiveness=1.000
aileron_effectiveness=1.050
rudder_effectiveness=1.000
pitch_stability=1.000
roll_stability=1.000
yaw_stability=1.000
elevator_trim_effectiveness=1.000
aileron_trim_effectiveness=1.000
rudder_trim_effectiveness=1.000

[Flaps.0]
type=1
span-outboard=0.750000
extending-time=40.000000
system_type=0
flaps-position.0=0.000000,0.000000
flaps-position.1=8.000000,0.000000
flaps-position.2=16.000000,0.000000
flaps-position.3=25.000000,0.000000
flaps-position.4=35.000000,0.000000


Versuch es mal hiermit!
Wenn es Probleme geben sollte,einfach fragen.
Ich kann Dir ja auch kommplett die Aircraft.cfg und AIRfile als zip zur Verfügung stellen.
Und wenn Du willst,könen wir ja den "Grundkurs" hier in diesem Thread erledigen.
Da gibt es einige Flugzeuge,die es nötig hätten.