Zitat:
|
WARNING: If the IDE configuration jumper on the Yamaha drive is in the 'CSEL' (Cable SELect) position then it must be temporarily repositioned to either 'SLAVE' or 'MASTER'. Failure to do so prior to executing the firmware update utility will most likely disable the Yamaha drive completely. The jumper can be repositioned to the 'CSEL' position once the update procedure is successfully completed.
|
das letzte update ist das, was ich schon installiert habe!
was heißt der warnhinweis genau? ich muss den brenner für das update umjumpern? hab ich vorher nicht gemacht - kanns daran liegen?
wie sollen eigentlich die kabel aussehen? ich hab den brenner und das dvd-laufwerk auf einem kabel (zuerst brenner, dann dvd - geht sich mit dem kabel so besser aus bzw. geht anders glaub ich gar nicht (ohne natürlich die laufwerke zu tauschen))
aida schau ich mir noch an - hab im mom keine zeit!
