Zitat:
Original geschrieben von santi
Hi Steve,
nur so aus Neugierde  - was macht denn das "makeactive" eigentlich, brauch ich das 
|
Hallo!
Ich hab mich da strikt an "info grub" gehalten:
File: grub.info, Node: Chain-loading, Prev: Loading an operating system directly, Up: General boot methods
Load another boot loader to boot unsupported operating systems
--------------------------------------------------------------
If you want to boot an unsupported operating system (e.g. Windows
95), chain-load a boot loader for the operating system. Normally, the
boot loader is embedded in the "boot sector" of the partition on which
the operating system is installed.
First, set GRUB's root device to the partition by the command
`rootnoverify':
grub> rootnoverify (hd0,0)
Second, set the "active" flag in the partition by the command
`makeactive'(1) (*note Chain-loading-Footnote-1:
:
grub> makeactive
Third, load the boot loader by the command `chainloader':
grub> chainloader +1
`+1' indicates that GRUB should read one sector from the start of
the partition. The complete description about this syntax can be found
in *Note Filesystem::. If this succeeds, run the command `boot'.
However, DOS and Windows have a deficiency, so you might have to use
more complicated instructions. *Note OS-specific notes::, for more
information.
Wenn es ohne geht kein Problem
Ciao,
Steve