<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Original erstellt von Woifi:
Ich hab mir jetzt auch schon den neuen LILO (v. 21.6-9)downgeloaded, das einzige was anders geworden ist, ist eine kleine Erweiterung bei der Fehlermeldung:
Warning: device 1x0309 exceeds 1024 cylinder limit Use of the "lba32" option may help on newer (EDD BIOS) systems-
Fatal: geo_comp_addr: Cylinder number is too big (2827 > 1023)
@Steve meine lilo.conf:
boot=/dev/fd0
install=/floppy/boot.b
vga=normal
read-only
prompt
timeout=100
image = /boot/vmlinuz
root = /dev/hda10
label = linux
other = /dev/hda1
label = win
table = /dev/hda
Die Zeile mit install hab ich selber hinzugefügt, bringt aber nix. Die Zeile in Deiner lilo.conf (map = /floppy/map) kenn ich nicht, was bewirkt denn die???
<HR></BLOCKQUOTE>
Hi Woifi!
Nicht die Nerven wegschmeissen!
Erste Möglichkeit: Die map-Datei sagt LiLo beim Booten wo der Kernel liegt und wird beim Aufruf lilo -C /floppy/lilo.conf automatisch auf der Bootdisk angelegt, LiLo braucht aber einen Verwies darauf in der lilo.conf!!
Oder zweite Möglcihtkeit:
Wenn du lieber mit dem neuen Lilo booten willst, und nicht von Disk, dann trag über oder unter vga=normal die Zeile "lba32" ein, ruf LiLo auf und er sollte auch über den 1024 Zylindern booten und du brauchst kein Part/BootMagic usw.!!
Hoffe dir geholfen zu haben,
Ciao,
Steve
------------------
"Let do what thou wilt be
the whole of the law!" A.C.
|