Du läßt nicht locker was?
Selbe Datei, andere Sektion:
[flaps.0]
type = 1 // 1 - tail, 2 - lead
span-outboard = 0.5 // 0.0 .. 1.0
extending-time = 5 // seconds
flaps-position.0 = 0 // degrees
flaps-position.1 = 10 // degrees
flaps-position.2 = 20 // degrees
flaps-position.3 = 30 // degrees
damaging-speed = 250 // KIAS
blowout-speed = 300 // KIAS
lift_scalar = 1.0
drag_scalar = 1.0
pitch_scalar= 1.0
system_type = 0 //0=Electric, 1=Hydraulic, 2=Pneumatic, 3=Manual, 4=None
Deine Parameter dürften:
extending-time
und die Flaps-position.0 bis x sein.
|