also, neuer stand:
ping geht auf winxp-rechner und zurück auch (die einstellung bei fw_route von 192.168.6.0/24 auf 192.168.6.2 geändert)
verbindung von linux ins internet geht auch (orf und aon kann man nicht anpingen, suse.de geht)
aber routen tut er mir nicht!!
route schreibt:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
172.19.95.184 * 255.255.255.255 UH 0 0 0 ppp0
192.168.6.0 * 255.255.255.0 U 0 0 0 eth1
10.0.0.0 * 255.0.0.0 U 0 0 0 eth0
loopback * 255.0.0.0 U 0 0 0 lo
default 172.19.95.184 0.0.0.0 UG 0 0 0 ppp0
und ifconfig:
eth0 Link encap:Ethernet HWaddr 00:02:44:2B:99:82
inet addr:10.0.0.1 Bcast:10.255.255.255 Mask:255.0.0.0
inet6 addr: fe80::202:44ff:fe2b:9982/10 Scope:Link
inet6 addr: fe80::2:442b:9982/10 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:154 errors:0 dropped:0 overruns:0 frame:0
TX packets:207 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:11 Base address:0xf200
eth1 Link encap:Ethernet HWaddr 00:40:F4:20:64:AB
inet addr:192.168.6.1 Bcast:192.168.6.255 Mask:255.255.255.0
inet6 addr: fe80::240:f4ff:fe20:64ab/10 Scope:Link
inet6 addr: fe80::40:f420:64ab/10 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:50 errors:0 dropped:0 overruns:0 frame:0
TX packets:32 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:9 Base address:0xf300
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
ppp0 Link encap:Point-to-Point Protocol
inet addr:62.47.217.216 P-t-P:172.19.95.184 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1490 Metric:1
RX packets:82 errors:0 dropped:0 overruns:0 frame:0
TX packets:89 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
ich verstehe das mit route.conf und routed nicht, was ist falsch?
|