Wie schon gesagt Computer neu starten (Scanner angesteckt und mit Strom versorgt), wenn der Scanner nicht automatisch erkannt wird, dann mit Hardware-Erkennung probieren. Geht das auch nicht´probier folgendes (hab´ ich von der Agfa-homepage):
First, make sure that the scanner is plugged in and properly connected to the LPT (printer) port on your computer.
If the software (FotoLook or FotoSnap) has already been installed and your system rebooted and your system will still not recognize the scanner you may need to remove the LPT port temporarily.
To do this, first boot your system to Safe Mode. (Refer to the documentation that came with Windows for instructions). Once in safe mode follow these instructions:
Click on Start.
Click on Settings.
Click on Control Panel.
Click on System.
Click on Device Manager.
Click on + sign next to SCSI Controllers.
Click on EPPSCSI mini port driver.
Click on Remove.
Click on the + sign next to Ports.
Click on Printer Port (LPT1).
Click on Remove.
Close the Control panel and reboot Windows. Your system should find the Printer port on bootup.
When your system is completely booted up, go to FotoLook or FotoSnap and the scanner should be recognized.
|