Vielleicht hilft das:
__________________________________________________ __________
try clearing cmos data to force a autodetection of all hdd and fdd units
this might have been corupted and some quick boot modes in bios don't
redetect your setup unless you ask them to.
<el_squid_2000@my-deja.com> wrote in message
news:8rqqdc$l9q$1@nnrp1.deja.com...
> Hi - I mounted the floopy on Suse Linux 6.4 yesterday in an attempt
> to load an ethernet card driver. This was successful, but the driver
> setup was not. I then tried to shutdown the machine using shutdown,
> which displayed a problem with the ethernet card, eth0..
> When I tried to boot up this morning, I get the following during the
> bios boot sequence:
>
> Verifying DMI Pool Data...
> Not found any [active partition] in HDD
> Not found any [active partition] in HDD
> Not found any [active partition] in HDD
> DISK BOOT FAILURE, INSERT SYETEM DISK AND PRESS ENTER
__________________________________________________ __________
Bei einem Normalen Biosflash macht er das ja nicht,oder liege ich falsch?
g17
|