Hier meine Anleitung, wie man VLAN auf dem SpeedTouch (incl. DHCP) konfiguriert:
Code:
bridge config vlan=enabled
eth vlan add name=VLAN2 vid=2
eth bridge vlan ifadd name=VLAN2 intf=OBC untagged=disabled
eth bridge vlan ifadd name=VLAN2 intf=ethport1 untagged=disabled
eth bridge vlan ifadd name=VLAN2 intf=ethport2 untagged=disabled
eth ifconfig intf=VLAN2 dest=bridge retry=10 wan=disabled priotag=disabled vlan=VLAN2 group=""
eth ifattach intf=VLAN2
ip ifadd intf=ip_VLAN2 dest=VLAN2
ip ifconfig intf=ip_VLAN2 mtu=1500 status=up group=lan linksensing=enabled primary=disabled mcastmode=default mcastpromisc=disabled
ip ipadd intf=ip_VLAN2 addr=172.16.123.1/24 addroute=enabled
ip ifattach intf=ip_VLAN2
dhcp server pool add name=VLAN2
dhcp server pool config name=VLAN2 state=enabled intf=ip_VLAN2 poolstart=172.16.123.1 poolend=172.16.123.20 netmask=24 gateway=172.16.123.254 server=172.16.123.254 primdns=172.16.123.254 dnsmetric=0 leasetime=0
dhcp relay add name=VLAN2
dhcp relay ifconfig intf=ip_VLAN2 relay=enabled maxhops=4 trusted=disabled
dhcp relay modify name=VLAN2 addr=127.0.0.1 intf=None giaddr=172.16.123.254
saveall
exit