[Seppel]

Und the last,

[electrical]
max_battery_voltage = 24
generator_alternator_voltage = 28
max_generator_alternator_amps = 60
engine_generator_map = 1,1
electric_always_available = 0
flap_motor = 0, 5, 17
gear_motor = 0, 5, 17
autopilot = 0, 5, 17
avionics_bus = 0, 5, 17
avionics = 1, 5, 17
pitot_heat = 0, 2, 17
additional_system = 0, 2, 17
marker_beacon = 1, 2, 17
gear_warning = 0, 2, 17
fuel_pump = 0, 5, 17
starter1 = 0, 20, 17
light_nav = 0, 5, 17
light_beacon = 0, 5, 17
light_landing = 0, 5, 17
light_taxi = 0, 5, 17
light_strobe = 0, 5, 17
light_panel = 0, 5, 17

[direction_indicators]
//1 Type: 0=None, 1=Vacuum Gyro, 2=Electric Gyro, 3=Electro-Mag Slaved Compass, 4=Slaved to another
//2 Indicator number of slaving indicator if Type = 4
direction_indicator.0=3,0

[pitot_static]
vertical_speed_time_constant = 1 //Increasing this value will cause a more instantaneous reaction in the VSI

[exits]
number_of_exits = 2
exit_rate.0 = 0.1 ;Percent per second
exit_rate.1 = 0.1 ;Percent per second

[TailHook]
tailhook_length=1 ;(feet)
tailhook_position=-15.0, 0.0, -1.0 ;(feet) longitudinal, lateral, vertical positions from datum
cable_force_adjust=1.0

[folding_wings]
wing_fold_system_type=4 ;0=None
fold_rates=0.075,0.075 ;Percent per second

[LIGHTS]
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing
light.0 = 3,-102.25, 0.00, 6.25, fx_navwhih ,
light.1 = 2,-102.25, 0.00, 3.00, fx_strobeh ,
light.2 = 1, 39.00, 0.00, 10.50, fx_beaconh ,
light.3 = 1, 20.25, 0.00, -11.50, fx_beaconh ,
light.4 = 4, 93.50, 0.00, 5.50, fx_vclighth ,

[Radios]
// Radio Type = availiable, standby frequency, has glide slope
Audio.1=1
Com.1=1, 1
Com.2=1, 1
Nav.1=1, 1, 1
Nav.2=1, 1, 1
Adf.1=1,1
Adf.2=1,1
Transponder.1=1
Marker.1=1

[forcefeedback]
gear_bump_nose_magnitude=3000 ; 0 - 10000
gear_bump_nose_direction=18000 ; 0 - 35999 degrees
gear_bump_nose_duration=250000 ; in microseconds
gear_bump_left_magnitude=2700 ; 0 - 10000
gear_bump_left_direction=35500 ; 0 - 35999 degrees
gear_bump_left_duration=250000 ; in microseconds
gear_bump_right_magnitude=2700 ; 0 - 10000
gear_bump_right_direction=00500 ; 0 - 35999 degrees
gear_bump_right_duration=250000 ; in microseconds
ground_bumps_magnitude1=1300 ; 0 - 10000
ground_bumps_angle1=08900 ; 0 - 35999 degrees
ground_bumps_intercept1=3.0
ground_bumps_slope1=0.20
ground_bumps_magnitude2=200 ; 0 - 10000
ground_bumps_angle2=09100 ; 0 - 35999 degrees
ground_bumps_intercept2=1.075
ground_bumps_slope2=0.035
crash_magnitude1=10000 ; 0 - 10000
crash_direction1=01000 ; 0 - 35999 degrees
crash_magnitude2=10000 ; 0 - 10000
crash_direction2=9000 ; 0 - 35999 degrees
crash_period2=75000 ; in microseconds
crash_duration2=2500000 ; in microseconds

[EFFECTS]
wake=fx_wake
water=fx_spray
dirt=fx_tchdrt
concrete=fx_sparks
touchdown=fx_tchdwn, 1

[keyboard_response]
//Breakpoint speeds (knots) on the keyboard increments of control surfaces.
//Speed at which the incremenet is reduced to 1/2 and 1/8 respectively.
elevator = 150, 250
aileron = 150, 250
rudder = 150, 250

[brakes]
toe_brakes_scale=0.671407
parking_brake=1
[gear_warning_system]
gear_warning_available=1
pct_throttle_limit=0.099976
flap_limit_power=29.220848
flap_limit_idle=5.042029
[hydraulic_system]
normal_pressure = 3000.0 //PSI
electric_pumps = 1 //no electric pumps
engine_map = 1,1,0,0 //pumps on Eng1,2
[stall_warning]
type=1
[attitude_indicators]
attitude_indicator.0=1
[turn_indicators]
turn_indicator.0=1,0


Ich hoffe ihr könnt damit was Anfangen,