Now - i have removed the TA-183 completley and install the T-183 Basepack.
When the plane stand on the rwy with engine On, they stand still and I can see no jumping.
But when I give power for take off they begin to bouncing.
Rotate with Flaps (I think 5 Degrees) at 100 knts.
And when i want to land, oh by good it is horrible because the wrong contact Points of the gears.
Now here are two pictures you can see the Scape-Points and I think they are wrong, too - like the Gear Contact points.
If anybody like to set the Scrape-Points illuminated - you make following change in your Aircraft.cfg:
( The other Lights are on Off - you must remove the // in front of light.0 and so on)
[LIGHTS]
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing
//light.0 = 3, -5.56, -16.45, -1.28, fx_navredm , //left nav
//light.1 = 3, -5.56, 16.45, -1.28, fx_navgrem , //right nav
//light.2 = 3, -12.32, 0.00, 3.53, fx_navwhih , //tail nav
//light.3 = 2, -2.56, -16.40, -1.28, fx_strobeh , //left strobe
//light.4 = 2, -2.56, 16.40, -1.28, fx_strobeh , //right strobe
//light.5 = 2, 5.00, 0.00, -4.50, fx_beaconb , //lower beacon
//light.6 = 1, 2.20, 0.00, -1.70, fx_beaconh , //upper beacon
//light.7 = 4, 6.00, 0.00, -1.25, fx_vclighth , //VC light
//light.8 = 5, 12.00, 0.00, -4.65, fx_landing , //landing light
//light.9 = 6, -6.62, 0.00, -2.60, fx_hustler_burner, //afterburner
light.10 = 3, -9.560, -16.300, -0.520, fx_navredm , //Scrap Points Light Left Wing?
light.11 = 3, -12.560, 16.300, 2.080, fx_navredm , //Scrap Points Light Right Wing?
light.12 = 3, -14.830, 0.000, 0.580, fx_navredm , //Scrap Points Light Backward Middle
light.13 = 3, -4.420, 0.000, -2.450, fx_navredm , //Scrap Points Light Front Middle