Kommt die Fehlermeldung unter WinME UND W2K?
Zitat:
SCSI/IDE Command aborted
If the error message SCSI/IDE Command aborted occurs:
Please check if there is a program accessing the burner. Please deactivate the option switch off the automatic to be deactivated for the drives. In particular if the error message only occurs actually during the burning process and not during the simulation.
Please check if the APM is active and if so, deactivate it.
Please check if background programs such as antivirus programs are active. Please close them down for the duration of the burning process.
If it is a case of a SCSI device, then please check the settings in the SCSI-BIOS . In particular Sync Negotiation should be set to yes .
If you use SCSI devices and a relatively large number of devices are connected to the SCSI-Bus, then you should please check if the SCSI-Bus may be overloaded and whether this can be solved by setting the maximum data transfer rate and by updating theWinASPI drivers.
If you are using an Adaptec SCSI hostadapter, the newest WinASPI drivers should be installed.
Please check if drivers of other CD burner programs should be loaded and if necessary deactivate these. (For example, if more than 78 minutes is to be burned, the above mentioned error message appears)
|
aus dem Helptool von Ahead.
Versuch mal die ASPI Treiner von Ahead:
http://www.ahead.de/de/download.htm