[Chwilami]

Hi everyone,
Me and my friend are trying to run an FSBUS according to schematics, layout, docs and firmware updated 3.5.06.
During our work with it , we have encountered a problem. It is connected with an I/O module.
In FS Admin everything works correctly. Switch and led work fine in every port.
The problem is when we are trying to use them in a program FS ROuter. There are a few problems:
1. Switch is working correctly in every port, but Auto Sense is only workin in port J6 in one position: 0,0.
2. Led`s are not working. In DO (LED) Test Leds also not working. And there is strange situation. When we mark any LED from the first line ( RID = 0 ) it causes I/O Module reset - red LED is showing number of CID. Can it be caused by uncompatibility between program flashed on Atmega microchip and FSRouter ?!? Or maybe the FSRouter has faults ? We belive that our I/O board was made correctly.


The most important for us is a problem number 2. We had also succesfull used a switch to operate gear in FS 2002. But we would like to use leds because our main task is MCP.


Could You please help us? What is a problem? How to solve it? If you could just write what version of FSRouter and Atmega program You use...

Please help us.

We do understand german, but still it is more easy to write and read english. Sorry for that...