Hi Kevin,
ok now I see what your setup is like.
It´s recommendable to run FSBus on the FS server as this is the easiest setup. As an example take my setup:
PC1 = Server with FS2004 + FSBUSrouter (connected via com1)+ PM MCP + 747 MCP (aerosoft)
Here FSBUS runs the radios You don´t need another PC for it.
Pc2 = PFD / ND + FsBusclient + WideFS
PC3 = PM CDU + SA_WXR + PM Upper / Lower Eicas (using PFD twice)+ FSBusclient + WideFs
PC4 = PMsystems + WideFS + FSBUSclient
Start with running your server + FSBusrouter and configure FSBusrouter to control the radios in FS2004.
If that works start a second PC and configure the FSclient ini.
If you control your hardware by Offsets / setting Bits and / or Bytes it should work flawlessly.
Only in case you send Keyboard commands from the FSBusrouter to an application running on a client you have to set a client ID in each of the FSclient ini.
Further you need to make sure in such case that the window of the addressed application is active before sending the keyboard command.
(See also FSBus command "W"
This is just to get you started. More details will follow after those steps have been successfully passed.
Good luck
Best rgds
Peter
|