@Andy
Hier sind die Antworten von Ariane zu Deinen Problemem. Ich lasse es gleich in Englisch damit es keine Missverständniss gibt. Ich hoffe ich konnte Dir damit irgendwie helfen. Gutes Gelingen und guter Flug.
Nette Grüße vom Jörg
Andy schreibt:
Die Lights lassen sich nur einschalten wenn ich bei der vorher geladenen default Cessna mit "L" sämtliche Lights einschalte und dann die Ariane lade. (kann ich mit leben).
Ariane antwortet dazu:
The Lights let themselves only switch on if I switch on Cessna with "L" all Lights with the previously loaded default and the Ariane then loads. (if I can with lives.
>>>A:
Please do not use any light switch MS default key board commands and expect them to work OK. Default [L] provides limited lighting control. We have much more lighting than the default command and therefore you must turn EACH SINGLE LIGHT to the ON or OFF position. We do not support [L] for single one-push operation. Its impossible. There are more lights to control and our logic does not provide for it. Stop being lazy... work a little.
Andy schreibt:
Das editieren des Flugplans Waypoint hinzufügen etc. führt nach wie vor zu einem Komplettabsturz des FS. (absolut inakzeptable).
.......Antwort Ariane dazu:
It may crash for your PC but it does not crash if entered correctly. Did you load the 9.1 patch from the FS2004 directory? Do not think you did.Re-install FS and the 9.1 patch and then re-install software.
Andy schreibt:
Beim Autoland fahren die gearmten Spoiler nicht nach dem Touchdown aus. (nervend weil es eigentlich so sein müsste).
Ariane antworte dazu:
Wrong. They pull out. Want a video to show it? What you are doing wrong? You did not engage the spoiler arm. Where is it? Read the manual. This is not a training school. Maybe Jorg will allow you to sit with the students and be taught how to do this
)
Andy schreibt:
A/T schaltet sich nach dem Touchdown nicht aus, was es beim Autolandverfahren eigentlich sollte und leider funktioniert auch die Tastaturzuweisung nicht (extrem Ärgerlich).
Ariane antworte dazu:
Does not work for what? This is called 'assumption' that it MUST work. It does not work like you think. Do not use keyboard commands for complicated cross key references. MS code does not support some of our multi-logic key responses - our work is highly complicated and we cannot (it is impossible) provide a one-key solution. You cannot ask a car to drive you - you must hold the wheel. Press buttons. Buttons that are not present are not provided. What is provided is present.
Our Comment: Auto one-key for lights? Automatic 'thinking' OFF key for AP etc. What is the point of flying a complicated aviation masterpiece if all you are doing is pressing a few buttons? If you want to watch a movie, see a DVD on the NG.
If you want to fly, learn to read some more...
Andy schreibt:
Ich hoffe das es sich um Anwenderfehler handelt und ich die mit Hilfe der Arianekenner beheben kann..
Danke schon mal
Gruss Andy
Ariane antwortet dazu:
Yes. I hope you are not unhappy with my comments. Its very difficult to make things to work how simmers 'want' them to work. We make things work the same as the real Ng - we do not make things work the way people demand.
These are not 'bugs' or problems. These are requests. We keep them for next time and maybe we consider them.
For me, we do not make requests. We make aircraft.
Thank you and best wishes
Bob
ARIANE STUDIOS