War das der Wortlaut in der Dokumentation?
ANNEX II. Programming and Configuration - Page 20 of 56
Manual Version 1.1, Software Version 1.7, 03/10/03
In TIPO (type) we will write the following values depending on the type of rotary switch that we are using:
- Blank if we are using a rotary switch.
- 1 if we are using 2-phased out digital encoders. They need an additional circuit (available at Annex III) and use two inputs instead three.
- 2 if we are using 2 bits Gray type encoders. They don't need additional circuits.
Das heisst soviel wie, dass du bei IO-Config in der Spalte "Type" eine "2" bei den Encodern eintragen sollst wenn du einen "Gray-Typ" verwendest.
Momentan ist dies für mich auch nur Theorie, aber ich hoffe am Freitag die Lieferung der bestellten Encoder zu bekommen.
Gute Nacht
1
|