[WolframB]

Hallo Don,

aus der original Bell206 aircraft.cfg:

[turboprop_engine]
power_scalar = 1.0

[propeller]
thrust_scalar = 1.0

Diese beiden Einträge suchen und Werte größer 1.0 eintragen, eventuell 1.2 testen.
power_scalar erhöht die Motor/Triebwerksleistung und thrust_scalar wohl den Rotorschub.

Bei "echten" FS Helis finden sich noch folgende Einträge:

[Helicopter]
reference_length = 21.58
reference_frontal_area = 17.7
reference_side_area = 44.5
side_aero_center = -12.5
right_trim_scalar = 1.0
correlator_available = 1
governed_pct_rpm_ref = 1.04
governor_pid = 0.4, 0, 0.1, 0, 0.2
rotor_brake_scalar = 1.0
torque_scalar = 1.0
cyclic_roll_control_scalar =1.0
cyclic_pitch_control_scalar =1.0
pedal_control_scalar =1.0
collective_on_rotor_torque_scalar = 1.0

[fuselage_aerodynamics]
drag_force_cf = 0.55
side_drag_force_cf = 10.0
pitch_damp_cf = -2.0
roll_damp_cf = -2.0
yaw_damp_cf = -0.1
yaw_stability_cf = 0.27

[MainRotor]
Position = -8.5, 0, 4.91 //Longitudinal, Lateral, Vertical feet from datum
Radius = 12.583 //feet
max_disc_angle = 5.0
RatedRpm = 510
Number_of_blades = 2
Weight_per_blade = 26.0
Weight_to_moi_factor = 0.58
inflow_vel_reference = 34.0

[SecondaryRotor]
Position = -22.8, -0.74, 1.8 //Longitudinal, Lateral, Vertical feet from datum
TailRotor = 1
Radius = 1.75 //feet

Gruß,
Wolfram