Im Handbuch steht es aber etwas anders. So viel ich weiß, wird die "ALIGN" Position des Drehschalters nur beim Quick Alignment benutzt, nicht beim Full Alignment.
To align the IRU’s, rotate each knob from
OFF to NAV (they are spring loaded to the
NAV position when rotating from OFF).
Selecting NAV will begin the alignment
process. Alignment requires approximately
ten minutes unless you have selected a
different figure from the PMDG/OPTIONS
menu.
Present position must be entered into the
POS INIT page of the FMC/CDU in order to
complete the alignment process. Alignment
can only be accomplished while the airplane
is stationary. Do not allow the airplane to be
moved during alignment. The Inertial
Reference System is aligned when all three
IRUs have entered the navigation mode at
the conclusion of their alignment period.
____________________________________
Grüße, Uwe
Asus A7N8X2.0 deluxe, Athlon 3000+, 1,5 GB Corsair XMS PC400 DDR Arbeitsspeicher, Asus GeForce N7600GS 256 MB, 120 GB Maxtor S-ATA Festplatte 7200, 300 GB Maxtor IDE Festplatte 7200, externe 300 GB LaCie \"Big Disk Extreme\" FireWire/USB2.0 Festplatte 7200, 2x LG DVD RAM, Audigy2 Soundkarte, BenQ FP93GX 19´ TFT, Vivanco SR2000 Kopfhörer
Asus A7N8X-E deluxe, Athlon 2500+, 1 GB Corsair PC400 DDR Value Select Arbeitsspeicher, GeForce 6600GT 128 MB, 80 GB Maxtor IDE Festplatte 7200, 80 GB Western Digital IDE Festplatte 7200, Pioneer DVD ROM, LG DVD RAM, Dell FP1907 19´ TFT, Creative I-Trigue L3500 Soundsystem
|