Zitat:
Original geschrieben von Mathew
you can use the IDs as you like
the IDs 1 to 7 are reserved for inputs though (FSKEY)
Do they work without the FSDO ???
Maybe you try flashing all the OUTPUT boards with ID larger than 7
But is should not affect it really.
Ole - i guess there is something wrong with one of the controllers - only a small item.
Please remove ALL the othe boards and start with the 2 Key controllers all over - if necesssary connect them to different ports on the COM interface, maybe even change the cables.
If there is no success use the PICs from trhe DO board (re flash them of course !)
good luck
Mathias
|
Really appreciate your help, Mathias!
There is no difference if the DOs are connected or not. Only issue is with the Key cards. If the Keycards are flashed with ID3 and ID4 the ID3 card is "unstable" - FSRouter only register some of the Keypresses. ID4 is OK. But if the ID3 card is connected without the ID4 card it works OK! I have tried a new PIC for the ID3 card. No matter if DOs are connected or not. If the Key cards are flashed ID1 and ID2 they both work OK! No matter if DOs are connected or not. Strange isn't it? It looks to me (like you say) there is an issue with the ID# beeing used. The DOs on the overhead are ID10,13,14. You say ID1-7 is reserved for Key cards! I was not aware of that. I have a LED controller with ID 7 (pedestal) in the FSRouter-program but not connected. Could that be the reason??
Anyway I'll try with an empty FSRouter file this evening.