Hi,
maybe you should consider control the IC's soldering and the conductor paths on your PCB.... maybe you have a cold soldering or you close a short circuit when pressing the IC.... or are the LEDs lighting up when you touch the metal pins of the IC?
I built my COM-board on thursday, but I need a new converter from USB to COM 'cause the old one got damaged....
As soon as I can get my FSBUS-NG running I'll check all this, also the things you mentioned with FSADMIN...
best regards,
Chris
____________________________________
beste grüße,
Christopher Haus-Air =)
---------------------
w w w . s i m - m o d u l e s . a t
[ Avionic Kits for Flight Simulation ]
---------------------
VISIT
www.HAUS-AIR.at
Der einfachste Weg, sich selbst schnell mal ein Cockpit zu basteln...
|