WCM Forum - Einzelnen Beitrag anzeigen

Pantu · 04.03.2005, 11:10

Hi Frans,

thanks for your posting.

My setup is as follows:

PC1 (3000+) = FS + MCP (PM) + MCP747 (Aerosoft HW)+ AS + FSBus + CDU HW -> Beamer

PC2 (1000) = PM EICAS + CDU + SA_wxr -> 2 Monitors (CDU + EICAS)

PC3 (700Mhz) = PFD / ND -> 1 Monitor

I´d like to control the CDU and Eicas by FSBus, using key commands rather than FSBus mouse clicks.
I´ve built the HW for the EFIS and EICAS using switches and rotaries (Knitter). The CDU HW is similar to the one Nico Kaan has made (simply push-buttons).
Is it posible to control Eicas and CDU (on same PC but different monitors)by FSBus, as to my knowledge, FSBus can address a certain Pc but not a window (yet?).

In other words the commands are going straight to the active window.

How could that be done?

Any hint highly appreciated.

Thanks and best rgds

Peter

04.03.2005, 11:10	#3
Pantu Master Registriert seit: 11.01.2001 Beiträge: 798	Hi Frans, thanks for your posting. My setup is as follows: PC1 (3000+) = FS + MCP (PM) + MCP747 (Aerosoft HW)+ AS + FSBus + CDU HW -> Beamer PC2 (1000) = PM EICAS + CDU + SA_wxr -> 2 Monitors (CDU + EICAS) PC3 (700Mhz) = PFD / ND -> 1 Monitor I´d like to control the CDU and Eicas by FSBus, using key commands rather than FSBus mouse clicks. I´ve built the HW for the EFIS and EICAS using switches and rotaries (Knitter). The CDU HW is similar to the one Nico Kaan has made (simply push-buttons). Is it posible to control Eicas and CDU (on same PC but different monitors)by FSBus, as to my knowledge, FSBus can address a certain Pc but not a window (yet?). In other words the commands are going straight to the active window. How could that be done? Any hint highly appreciated. Thanks and best rgds Peter