Hello Ewald,
Sorry i will have to answer you back in english so i hope you understand it. If not that i am sure someone on this forum helps you with a translation.
The Airbus PM software works perfect with the goflight modules. Also your GF-autopilot works ok the only think you have to remember is that you also need to FCU of PM to get it all working otherwise you will miss some functions or they dont work ok.
You can use instead of the ECAM of PM also the software of HCSTD (like i also do) and it works as well in combination with PM.
The overhead is also possible to get on a screen with the software of HTSCD. On there site you find some demo's you can see and if you have any question about the product they have, just send them a email and they will help you out.
I also use extra the software of FS-Communicator. This makes the Fly-by_wire possible and the dual stearing as well. This program communicated again very well between the HCSTD and the PM software and it is also possible to connect pots over a joystickport to controle your throttle levers for instance.
With other words there are a lot of software programs that can work very well together it just is a question of time and sometimes with help of others to get it all working. But when it works it looks great. Just remember that it is better to have seperate comps to run your software on so one comp for your FS than one for the PM/ND and one for the HTSCD...
Run everything on 1 comp will ask to much mem and will slow down a lot or not even work.
Widefs is also needed and FSCuip as well to make the communication between all your comps in a network.
Succes
Frans
www.planesonline.nl