Suche FSUIPC offset
 

Hallo,
kann mir jemand mitteilen, welcher FSUIPC offset es gibt um die aktuelle Joystick Position der Schubkonrolle auszulesen.
Ich habe einen gefunden und zwar
088C = Engine 1 Throttle lever, -4096 to +16384
Wenn die automatische Schubkontrolle aktiv ist wird die Joystick Achse deaktiviert und die Positionsteuerung des Throttle kommt vom FS.
Hintergrund ist ich möchte eine richtige automatische Schubkontrolle in mein Cockpit einbauen; dafür habe ich mir ausgedacht das ich den Offset 088C als Sollwert nehme, und den noch unbekannten Offset des Joystick als Istwert. Die beiden Werte werden miteinander verglichen und dementsprechend wird der Motor für die Schubkontrolle vor oder zurück gedreht bis Soll und Istwert identisch sind.

kann mir jemand helfen?
Gruß Peter

In what program do you try to put this offset?

gr.

Frans M

indeed
 

indeed a good question :eek:

rico

I want use this new unknown offset in FSBus or in a visual basic application

Unknown in FSBUS????

1, "Engines"
2, "Engine1"
3, "Throttle Lever",148, 0, 0x088c, I16, 0,RW, 10,1,1,

just standing in your standard fsini....

gr.

Frans M

you have misunderstood my question.
I search an offset which show me the real joystick throttle axis value, independently if the autopilot thrust control is activated.

When I use the "Throttle Lever",148, 0, 0x088c, I16, 0,RW, 10,1,1,
and the autopilot thrust control is activated and I move the joystick throttle has the offset 0x088c only the value from the autopilot throttle.

I hope you understand my question, its difficult to explain to you.

No sorry i dont understand it really..

To controle you eng 1 throttle you use the offset as mention 088C this is also the offset of FSUIPC you will see the eng 1 throttle move from idle to full and back when you move the joystick

when you would put out the joystick it will not response only when you would send a direct offset via FSCUIP of 088C to the FS...

When you have the autothrottle ON ( not sure where you look to this and if you use it in FS or any other prog like PM) your autothrottle will automatic put your ENG1 to full you cant manual take it back...

but ones again i am not really sure what you try to do and what you want specialy

gr.

Frans M

PS.. boeing or airbus you build?

I want build in my boeing cockpit an automatic moving throttle with an electric motor.
While the autopilot is active, I want use the Offset 088C as desired value and and the still unknown offset of the Joystick Throttle as actual value.
i want compare these two offsets and trigger the electric motor forward or backward.